Cone Valve Spec Sheet: 

Spec Sheet | Literature

You can copy and paste this information into your word processor.

General
The cone valve shall be cast ductile iron construction as manufactured by the Henry Pratt Company. It shall have a full, unobstructed waterway equal in diameter to the size of the valve required.

Elements
The cone valve shall consist of four basic elements in its construction:


  • Body: The cast ductile iron body shall have a clear, unobstructed waterway in the inlet and outlet flange.

  • Plug: The plug, which is the conical closing element used within the body, shall have a clear, unobstructed waterway.

  • Cover: The cover is the method used to encase the plug within the body and support the operating mechanism.

  • Operating Mechanism: Attached to the cover, this mechanism performs the open and close function for the valve.


Construction
The valve shall be designed to operate under the conditions specified.

The valve body shall have welded monel seats raised above the surface of the casting. The waterway flanges shall conform to ANSI B16.1-CL.125# or 250#.

The plug shall have either one or two seats of welded monel seats, also raised above the surface of the casting. Two seats are used if there is a need to protect the body seat in the open position.

The valve shaft shall be an extension of the upper trunnion. It shall be securely pinned in position and, where it passes through the cover, chevron packing will form a seal.

Bearing stresses shall not exceed 3000 PSIG. The valve can be used in a vertical or horizontal position.

Operation
The operation of the cone valve shall take place by using an axial motion to unseat the plug and lift it above the seat surface. The plug will rotate 90 degrees from the open to the closed position and then re-seat, all in a single operation.

  • Body: Cast ductile iron ASTM A536 GR 65-45-12

  • Plug: Cast ductile iron ASTM A536 GR 65-45-12

  • Cover: Cast ductile iron ASTM A536 GR 65-45-12

  • Seats: Welded monel overlay

  • Shaft: Stainless steel type 630

  • Body Bushing: Bronze ASTM B584-C92300

  • Plug Bushing: Bronze per SAE-660


Scope of the Line
The size range shall be 6 to 60 diameter. The valve is rated for use in applications up to 300 PSIG and shall have ANSI CL.125# or 250# flanges.

Types of Actuation
The valve shall be actuated by one of the following methods, as specified.

  • Hydraulically, using a cylinder for water, air or oil

  • Electrically, using a motor operator

  • Manually, using a handwheel or AWWA square nut


Testing
With the plug in partially open position and blind flanges on the upstream and downstream waterways, the valve shall be hydrostatically tested using two times the required working pressure for thirty minutes. The casting shall show no sign of leakage or distress. With the valve in the closed position and the working pressure applied to one side at a time, leakage shall not exceed 0.4 oz./min./inch of diameter.

copyright 2017 Henry Pratt Company | all rights reserved. Henry Pratt Company is a subsidiary of Mueller Water Products, Inc.
privacy policy
HYDRO GATE | MILLIKEN VALVE | US PIPE